Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Schlage button flashing red once ”

Resolution: A Credential Reader MAY be replaced with another Credential Reader of the same type; however, a Factory Default Reset must be performed before the lock will function properly.:

How to Reset a BE367 Deadbolt to Factory Settings

Resolution: For resetting a PED500 / BE367 deadbolt back to factory status, refer to attached guide: Deadbolt Reset InstructionsProgrammable Electronic Deadbolt: RESET back to factory settings It ...:

What are the TWO red SCHLAGE flashes on an AD400?

Resolution: ONE red flash, One red flash indicates RF COM loss, the AD400 radio did not get an answer from the PIM400-485 radio or the PIM400-TD2 radio. The PIM400-485 will turn off it's radio if th...:

Why did my CO Lock stop working after the Reader Module (electronics) was changed?

Resolution: CO Reader Modules are not individually replaceable, nor can they be swapped between locks. The inside and outside assemblies of a CO lock are a matched/mated set and cannot be swapped to change rea...:

Why would an LCN 8310-865 RF Receiver have a flashing "RED" light?

Resolution: When the "RED" LED on the 8310-865 RF Receiver is blinking, it is receiving an RF signal (interference) from a non programmed device. When receiving this type of signal, it will not ...:

What is the low battery threshold for the AD and CO Locks?

Resolution: CO200 & CO250 Disable coin cell Nuisance delay and blink, With CO.A.7 and SUS 4.10.2 or newer for CO200 and CO250, you can use the SUS/HHD, under Lock Properties, Edit, to de-select, DISABLE, t...:

Is there a Schlage lock with a toggle button?

Resolution: The only Schlage lock with a toggle was the discontinued K-Series mortise lock.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Schlage button flashing red once ”

RELATED FAQS