Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ rated compression anchors ”

Resolution: For compression anchor details refer to the “ANCHORING SYSTEMS” section in the Steelcraft Tech Data Manual.Anchor Quantities: • 1 compression anchor per jamb through 9"depth • ...:

Are masonry T anchor fire rated?

Resolution: Masonry T anchor are approved for fire rated frames up to 3 hours. T Anchors are shipped lose for field installation. Anchor construction: The T portion and the strap do have minimum dim...:

Can an additional jamb anchor be used as a base anchor on fire rated frames?

Resolution: Yes, an additional jamb anchor can be used at the bottom of the frame in lieu of the typical (adjustable or weld-in) base anchor in fire rated frames. This is limited to the anchor designed for...:

Door hitting the strike jamb?

Resolution: If the door hits the frame (or rubs on the rabbet of the head or jamb) the frame is out of square and improperly installed. Door edge rubbing on the rabbet - shimming the hinges may resolve the...:

What are security jamb anchors?

Resolution: Security anchors are used in DW/K frames located directly above or below strike preparation on door side of frame. Because there are only two points of anchoring, the compression anchor near the ...:

What is the difference between the DW-Series and K-Series frames?

Resolution: Both the DW and K-Series frames are identical with the exception of the base anchoring. Both the DW and K-series frames are supplied with a field adjustable compression anchor in each jamb locate...:

What is the part number for the blocking ring for use without compression ring?

Resolution: The part number for a Schlage mortise cylinder blocking ring for use without compression ring is the 36-079 (specify dimension and finish).:

Are adjustable base anchors provided with frames that are prepped for existing opening anchors?

Resolution: No, an adjustable base anchor is not supplied on frames with existing opening anchors. The anchor design for use in existing masonry walls, is a pierce and dimple in the frame soffit for 3/8"...:

How many P & D (Pierce and Dimple) holes are in a frame?

Resolution: The following are quantities of EMA anchors (pierce and dimples) based on range of frame height: Quantity Nominal Frame Height 2 1'...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ rated compression anchors ”

RELATED FAQS