Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Pull arm template senior swing ”

RELATED FAQS

Resolution: The SEH is an "electronic holder" (ONLY) that is used to hold open a Fire Rated opening. It requires a door closer to be mounted on the opposite side. It is normally used on an existing opening wit...:

What is the template for 5BB1HW for Swing Clear Hinges?

Resolution: The 5BB1HW Swing Clear Hinge templates can be found using this link.:

What is the maximum degree of opening you can template a 4110 Cush closer?

Resolution: The 4110 Cush closer can be templated for 85°, 90°, 100°, and 110° maximum as standard templates.The 4110 if ordered by ST-3220 will allow templating to 135°:

Where are hardware templates?

Resolution: All the templates can be found at us.allegion.com Please click here :

Can a 9500 series operator on the push side be used with Cam lift hinges?

Resolution: The Senior Swing will work with Cam Lift Hinges as a PUSH SIDE MOUNT 9542/9553/9563 only. Maximum 3/4" lift. Maximum 15 pounds force to push door up the Cam Lift Hinge. Cam Lift Hinges WILL NO...:

Will a Senior Swing or Swing IQ work with swing clear hinges?

Resolution: Push Side Surface Mount Senior Swing or Swing IQ can be used with swing clear hinges, standard butt hinge/offset pivot templating. Pull Side Surface Mount Senior Swing&nb...:

How do you install the LCN 9530 Senior Swing (STD) pull arm?

Resolution: When installing the arm; the gearbox shaft and door must be at the (+90°) full open position. The following step are used to install the Senior Swing (STD) pull arm. Install...:

What is the power draw of a Senior Swing series operator?

Resolution: The Senior Swing (2800/9500) Series operator has a 120VAC @ 2.5 Amp current draw for a single door (2811/9531/9542) or simultaneous pair(2853/9553). The independent pair units (2863/...:

How do you install the LCN 9540 Senior Swing (REG) push arm?

Resolution: When installing the arm; the gearbox shaft and door must be at the (+90°) full open position. The following step are used to install the Sr. Swing (REG) push arm. Install t...:

Can you mount a 4041 Cush arm with a EDA arm template and get 180 degrees opening?

Resolution: The dead stop post would need to be removed and the 4040/4040XP EDA mounting template for 180° would be followed.: