Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ new track and roller SE ”

RELATED FAQS

Resolution: The SEH is an "electronic holder" (ONLY) that is used to hold open a Fire Rated opening. It requires a door closer to be mounted on the opposite side. It is normally used on an existing opening wit...:

What is the part number for the plate and the 2030 cylinder?

Resolution: Part numbers listed below: 2030-3071 cylinder assembly includes the closer cylinder and finish plate. 2030-3971 is the cylinder only. 2030-3002 is the finish plate. 2030-3077T is ...:

Is there an identification chart for all the different rollers that LCN has?

Resolution: On Feb 8th, 2016 - LCN launched the redesign of the Hold open clip which changed multiple components of our Track style closers, including the roller, track, hold open clip, and bumper. :

What special template (ST) is used with the 2030 closer and a low profile track and roller?

Resolution: The 2030 closer requires a minimum 1-3/8" top rail on the door for the standard track. For a top rail less than 1-3/8" and as narrow as 1", you could use the l...:

What is the part number of the most recent SE track?

Resolution: The SE series track is the same for all models. It is ordered by the closer model, followed by a -3038. Example -- 4040SE-3038 (specify voltage & finish) or 3130SE-3038 (specif...:

Is there a left hand hold open clip (block) for a 3130 series closer?

Resolution: As of Feb. 8th, 2016- LCN launched a new HO feature (block) for all track closers, which is not handed. Part # for the Hold Open clip (block) is 3130-3054 and it also requires the...:

How do you install the LCN 9530 Senior Swing (STD) pull arm?

Resolution: When installing the arm; the gearbox shaft and door must be at the (+90°) full open position. The following step are used to install the Senior Swing (STD) pull arm. Install...:

Why would a Falcon 8200 operator have an inconsistent opening?

Resolution: An inconsistent opening is normally caused by the arm not being installed correctly. The arm must be installed while the operator gearbox is in the full open position, and the door at 90° open posi...: