Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ CX not alarming ”

Resolution: For Solenoid driven Chexit devices shipped from the factory prior to 8-24-2015, the following could cause the device not to provide delay egress:Measure the voltage between green and orange wires o...:

Why is my Von Duprin CX going into a weak alarm after the rearm delay?

Resolution: Chexit devices shipped prior to 8-24-2015 with solenoid - the solenoid pulls and drops, the alarm sounds, there is a solid LED or no LED light after the rearm t...:

Von Duprin Chexit device keeps going into alarm by itself.

Resolution: Chexit devices shipped with solenoid prior to 8-24-2015. 1. When Chexit device is set for more than zero second rearm time (factory setting is 10 second rearm time) and device goes...:

Is there a way to get a dry contact signal from a Chexit device when it is in alarm?

Resolution: To get a dry contact signal from a Chexit device to monitor the alarm, use the blue and brown wires (do not connect the blue to the red) of the harness connector cable tha...:

Chexit goes into alarm with fast flashing LED and not locking after rearm time.

Resolution: Chexit devices shipped prior to 8-24-2015 with solenoid driven: Chexit device has a RX switch with a connector that needs to be connected to the Chexit module otherwise the alarm will sound af...:

Solenoid on Chexit pulls back and immediately lets go and alarm goes off with red solid light.

Resolution: The following could cause the Chexit solenoid ( devices shipped prior to 8-24-2015) pulls in then drop out with no alarm. Mechanical adjustment such as vertical rods. Disconnect t...:

Why does my Chexit device open without sounding the alarm?

Resolution: :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ CX not alarming ”

RELATED FAQS