Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Can you use dummy trim on a rated device?

Resolution: We do not recommend as Fire rated devices are always latched and they would not be able to unlock and pull the door open.:

What is the max rating available on an full glass (FG) door?

Resolution: A UL 20 minute fire rating is the maximum fire rating for a Full Glass (FG) door design. A14-Series door construction: Max fire rating is 20 minute. UL label only FG must use Over-Lapping Stee...:

How do you install an L9000 lock less outside escutcheon trim?

Resolution: "L" Escutcheon trim mounting Although this is NOT recommended, in some instances this may be your only option. You can order 2 each of the L583-287 (L Escutcheon mounting screws for dummy tri...:

Is there a special thumb piece for 880TP on 2-1/4" door?

Resolution: No special required, cut the length of the tailpiece for 2 1/4" thick door per installation instructions.:

What is the standard screw size used on Steelcraft doors with 4 1/2" or 5" hinges?

Resolution: Steelcraft follows the industry standards for hinge reinforcement and preparation for both door and frame. Unless otherwise specified all products prepared for butt hinges will have mounting holes ...:

How many 25 FSE trims can be powered by a PS914 x 900-8F?

Resolution: Falcon 510 FSA/FSE trim for 25 series exit device draw 0.4 amp. You can install up to eight electric trim to PS914 x 900-8F power supply since the 900-8F board has eight outputs.:

How long is the 98/9927 rod connector?

Resolution: The center case rod connector is 1" long. The latch case rod connector is 1-7/8" in overall length.:

Is the 1490 handing field reversible?

Resolution: Handing can be changed, see step 3 of the 1490 installation instructions.:

Can HD-EL be used on 33A/35A device?

Resolution: The Von Duprin 33A/35A series exit devices can be order with HD-EL option.:

How do you set up Windows' "Hyper Terminal" for console port troubleshooting on a biometric GT-400?

Resolution: You can use Windows' "Hyper Terminal" to configure console port troubleshooting, set up a serial connection, and/or set up RS232 output on a biometric GT-400: For the COM setting, go into the C...: