Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What replaced the 40-019 1 inch boring bit?

Resolution: Unfortunately, there is no replaceable bit.:

Is there a way to get a dry contact signal from a Chexit device when it is in alarm?

Resolution: To get a dry contact signal from a Chexit device to monitor the alarm, use the blue and brown wires (do not connect the blue to the red) of the harness connector cable tha...:

How to replace the circuit board or horn on a Guard-X device?

Resolution: See PCB replacement instructions below. The horn is part of the board and can only be replaced by replacing the entire board.:

How to wire 873-4TD to have 1 input trigger 2 EL devices?

Resolution: To trigger two EL devices with one access input, wire your input into SC & I1, the first two screw terminals, then jump from I1 to I2 terminals.:

Do we have a maximum door width or height for using pivots?

Resolution: The maximum door width that pivots have been tested is a 4' wide door. Any door greater than 4' would shorten the life of the pivots. There is no maximum door height, for offset pivots the ru...:

Is there a service kit for modular cylinders?

Resolution: A service kit is available, part number 40-223. Product description available HERE. For pictures of the parts in the kit click here. :

What is the part # for the threaded rod only on the Senior Swing regular arm?

Resolution: The part # for the threaded rod "only" on the Senior Swing regular arm is 9540-82 or 9540-82L (long rod only).:

Is EL and SD available togther on the 33A / 35A devices?

Resolution: Cylinder dogging (SD) which is contained in the head of the device and 33A/35A device head is not wide enough for a SD cylinder dogging.:

Can a magnet, or sentronic device, be released and close the door from a button at a desk?

Resolution: If a door is being held open by the LCN SEM 7800/1900 magnet or any ME/SE Series Sentronic LCN closer, you can remotely release that door to close by ordering the following parts and wiri...:

What is the part number for the Schlage small format rim cylinder tailpiece?

Resolution: B502-899 is the tailpiece for both the SFIC and standard rim cylinders.: