Can I change an AD lock from an 8 "AA" battery pack to a 4 "AA" battery pack?
The AD lock battery pack type can be changed following this procedure:
1. Disconnect the existing battery pack
2. Depress and hold the SCHLAGE button for a few seconds to drain off any residual charge
3. Connect the new battery pack; the lock should execute a normal power-on procedure
4. Connect the HHD and check "Power Status" under "Lock Properties"; the correct battery pack type should be indicated
If the incorrect battery pack type is shown, disconnect the HHD and perform an S1 switch reset on the Main PCB
Re-check "Power Status" using the HHD
If changing from an 8-pack to a 4-pack, the user will need the Four-Battery Holder Kit, part number 4B. Finish must be specified.
If changing from a 4-pack to an 8-pack, the user will need the Eight-Battery Holder Kit, part number 8B. Finish must be specified.
DISCLAIMER:
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES
OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO
YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE
USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS
MADE AVAILABLE THROUGH THIS SITE.