schlage finish delay

RELATED FAQS

Question
Answer
The PS914 x 900-2RS option board doesn't have time delay. If time delay is required specify PS914 x 900-4RL. 900-4RL provides up to 75 seconds, 5 second  increment unlock time.
The commercial Aged Bronze finish (643e) is the BHMA equivalent to a copper plated, blackened, relieved and then clear coated product. This commercial finish is identical to the residential Aged Br...
Beginning January 2, 2013 Schlage will offer the Latitude (LAT) and Longitude (LON) levers in the 629 and 630 stainless steel finishes.
Please contact the Allegion Product Support Team on all questions or inquiries pertaining to hardware finishes warranties. Please send an e-mail to the applicable Product Support team:Closers_TechP...
Finish is not specifically stated as being covered under warranty as it is covered under defects in material and workmanship.  EXCEPTION: There is no finish warranty for Falcon products. ...
Falcon lock warranty statementIves warranty statementGlynn-Johnson warranty statementLCN closer warranty statementSchlage warranty statementSteelcraft warranty statementVon Duprin warranty statement
See letter excerpt below.  Parts are no longer available.Effective June 30, 2000 Schlage Commercial is announcing the obsolescence of the ME-Series and ULTIMA 505 bright brass finish option fo...
The ME trim was discontinued in 2001 and no longer available.
The part number for a Schlage mortise cylinder blocking ring for use without compression ring is the 36-079 (specify dimension and finish).
A 626 or US26D.  Schlage definition of the 626 is a satin chromium plated finish.
The coin cell Nuisance Delay on CO200 and CO250 can be temporarily disabled using the Schlage Utility Software.
Once disabled via the SUS application, the CO lock will no longer delay the access for valid credentials.
If your CO lock began indicating a low coin cell (Nuisance Delay) after a door file has been downloaded, the coin cell is low and should be replaced. (CR2032)The coin cell Nuisance Delay will be "A...
The coin cell Nuisance Delay settings in the SUS application is not available until such time that a Door file is successfully downloaded to the lockset.
The coin cell is ignored when the lock sets are used with Manual Programming ONLY or while in Construction mode.
Schlage offers 629 and 630 stainless finishes on levers for the L-Series only.  These levers are made of 303 or 304 grade stainless steel.