Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ What wire is needed for EL devices ”

Resolution: For Product Shipped prior to 8-24-2015 with solenoid and EPT or Door Loops: a. 0-100 ft, use #14 Gauge Wire ...:

What is the power output of a 4600 operator?

Resolution: The 4600 Series operator has both a 12VDC and 24VDC output rated at 1A (combined load) to power strikes, maglocks, and other devices, but an EL device must have a separate Power Supply for motorize...:

Why is the Von Duprin PS873 power supply buzzing or chattering?

Resolution: Some transformers in the power supplies provide a little humming noise and that is normal. If the humming in Von Duprin PS873 power supply is loud follow these steps. Remove the load from the outp...:

Does the wire size of an EPT affect the operation of an EL device?

Resolution: Since most wire transfer devices such as an EPT or electric hinges cannot provide large gauge wires, we take the small gauge wire into account when determining the overall wire size for the device....:

Is there a template that shows where to drill the hole for E/EL/SS/RX/LX/CX wires?

Resolution: The hole should be drilled in the field once the end cap is located on the door. It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...:

What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?

Resolution: :

What size wire and run is recommended when using a PS914-2RS?

Resolution: For Product Shipped Prior to August 2012 using the old (black) potted module:a. 0-100 ft 14 gauge wireb. 0-200 ft 12 gauge wire&nbs...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ What wire is needed for EL devices ”

RELATED FAQS