Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ warranty for door closer ”

Resolution: See here for our Warranty Information. :

What is the minimum dimension from the edge of the door to a glass light cutout?

Resolution: Minimum dimensions to cutouts for glass lights: Vertical edge of door to edge of cutout = 5 29/32" Top of door to top of cutout = 6" Bottom of door to bottom of cutout = 10" Reinforcing chann...:

Can you order a 1461 cylinder only?

Resolution: The part number is: 1461-3071 for the door closer cylinder body.:

What is a 62A shoe used for?

Resolution: The 62A shoe is used when it is necessary to install the door closer (lower) down on the door so that it will operate under accessories such as overhead stops, coordinators, etc.:

In what direction should the hold open nut be pointing for a 4041 H closer, up or down?

Resolution: Make sure that the hold open nut is not on upside down. The orientation of the hold open nut depends on the mounting. On a Top Jamb "Push Side" mount, the hold open nut would poi...:

Can the 4630/4640 cylinder only be replaced?

Resolution: The 4040(XP) door closer can be used as a temporary replacement in a 4630/4640 operator to provide manual control of the door while the 4630/4640 closer cylinder is being repaired or a replacement ...:

What are the dimensions of the SC70 footprint

Resolution: The measurements from center line to centerline of the mounting holes are 2-3/8" x 6-3/4".:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ warranty for door closer ”

RELATED FAQS