Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ von duprin exit device controls ”

Resolution: Position the 379L trim and attach with countersunk screw into the bottom stud of the trim. Position the 55 Rim device and attach with the device mounting screw through the head of the de...:

What is needed to keep the EL device retracted all day?

Resolution: To keep the Von Duprin electric latch retraction EL or QELA exit device dogged (retracted) all day, have your access control, Key pad, key switch, fire alarm contact or any other signals ...:

Does Falcon offer a Delayed Egress exit device?

Resolution: There is not a fully self-contained delayed egress like a Von Duprin Chex-It device but the Falcon RX-24 or RX-25 Series can perform a delayed egress by using the DE5300 controller, power supp...:

What are Pneumatic Automatic Operators?

Resolution: Pneumatic Automatic Operators are used in areas where electrically operated devices are not convenient or permitted. Consists of a modified, heavy-duty door closer for manual oper...:

What parts do I need to add to the bottom rod of my existing Von Duprin 8827 LBR exit device?

Resolution: To add the bottom rod and latches on 8827LBR it requires Bottom Rod Kit part #050455-XX 8827 Rod Guide Kit part #50482-XX 8827 LR Bottom Latch Kit W/Cover part #050467-XX 304L Bottom Strike:

Is the SD option available with Von Duprin QEL 98/99 exit devices?

Resolution: SD option is available and is also standard with Von Duprin 98/99 rim and vertical rod exit devices but not available with mortise device.:

Do we offer HD-QEL?

Resolution: We offer a couple different HD-QEL options:Hex key dogging (HD) is now available with Von Duprin non fire-rated QEL 33A/35A/98/99 electric exit devices that were shipped after D...:

What would cause an EL device to pull and release?

Resolution: If your Von Duprin EL (solenoid) device pulls and releases quickly instead of holding the latch retracted, please check all of the items below.In most cases, one or more of these solutions will r...:

What power supply is needed for EL devices?

Resolution: You can use a Von Duprin PS914 power supply with any of the following option boards depending on the application. 900-2RS board will power 1 or 2 devices that do not require timing from pow...:

Can I use an AD or CO - 993 Exit Trim with a Von Duprin 98/99 Concealed Vertical Rod exit device on a wood door?

Resolution: The AD or CO - 993 is NOT compatible with a Von Duprin 98/99 Concealed Vertical Rod exit device on wood doors.:

What is (SD) Special Dogging?

Resolution: SD is Special cylinder dogging in the center case of 98/99 rim and vertical rod non fire rated devices and is available with standard, EL, QEL, CX and ALK.:

What is the difference between the 376T and the 360T trim when it is used with Von Duprin 33/3547A exit device?

Resolution: The 376T trim activates and connects to the 33/3547A top rod. The 360T activate and mounts to the 33/3547A center case.:

Does EL or QEL conversion kit for Von Duprin exit devices contain mechanism cover plate?

Resolution: The conversion kit does not contain a new mechanism case cover plate. If a cover plate is desired, you would need the Fire or Less Dogging Cover Plate for EL/QEL conversion kit and Panic cove...:

Can the Von Duprin exit alarm ALK and electric latch retraction QEL or EL device be in the same device?

Resolution: No, Von Duprin exit alarm ALK and electric latch retraction QEL or EL are installed in the same location and can't be ordered together with the same device.:

Is there any way to lock the push side of an opening with a Von Duprin exit device?

Resolution: You cannot lock the push side of the exit device as a panic device by design must allow exit. Any attempt to block an exit is forbidden by code.:

Is the AD CO with a 993 chassis compatible with the Von Duprin 33A exit device?

Resolution: No, the 33A is not compatible with the AD and CO 993 chassis units. The 33A can only be driven in a clockwise direction. This would restrict it to right hand installs only.:

When were 313AN & 315AN anodized finishes changed to SP313 (695) and 622 powder coat finishes?

Resolution: Beginning December 6, 2010, all 33A, 35A, 98 & 99 devices ordered as 313AN Anodized was furnished in SP313 (dark brown powder coat). All devices ordered as 315AN ...:

Warranty information on Allegion Commercial products.

Resolution: See here for our Warranty Information. :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ von duprin exit device controls ”

RELATED FAQS