Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Von duprin EL wiring diagram ”

RELATED FAQS

Question
Answer
Is there a wiring diagram for EL and Von Duprin PS914-2RS power supply?
Reference The 914 Installation instructions.
Where are Allegion Wiring and Riser Diagrams (Von Duprin, Schlage, LCN) ?
Wiring and Riser diagrams can be accessed at:Common wiring diagrams can be accessed at:  http://kc.allegion.com/.   Click on the "Common Wiring Diagram" link.To request a custom wiri...
Why is the EL wiring adaptor now required when using the new PS900 power supplies?
Products shipped on or after August 8, 2012 no longer require the EL wiring adaptor. The ELK Wiring Adaptor (900ELK) was used only when using the PS914 power supply with either the 900-2RS or 900-...
Is the the PS914 EL wiring adapter needed for Von Duprin Chexit device?
The EL Wiring Adapter is not needed for a CX device.
How do I wire an EL device to normally hold open the latch and release it during a fire alarm?
Use a normally closed fire alarm as the input to the power supply option board (PS873-2 or PS914-2RS), this will hold the latch retracted.  During a fire alarm, the contact will open, dropping...
What gauge wire is needed for a CX device?
For devices shipped after 8-24-2015 with motor driven:  a.       0-200 ft, use  #18 gauge wire b.      0-500 ft, use #14 gauge wir...
For Product Shipped prior to 8-24-2015 with solenoid driven:          a.       0-100 ft, use #14 Gauge Wire      b.&n...
What is the power output of a 4600 operator?
The 4600 Series operator has both a 12VDC and 24VDC output rated at 1A (combined load) to power strikes, maglocks, and other devices, but an EL device "always" has to have a separate PS914-2RS Seri...
What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?
  For Product Shipped Prior to August 2012 using the old (black) potted module: a.       0-100 ft 14 gauge wire b.      0-200 ft 12...