Straight cam installation

RELATED FAQS

Question
Answer
The straight cam should be installed on the outside cylinder and the clover cam on the inside.
20-059 is the standard straight cam FSIC housing only used with Von Duprin, Monarch, and other straight cam applications. 30-032 is the straight cam FSIC housing only for the outside of the Schl...
Effective July, 2014, there is no longer a specific modular cam part number for dogging. The Schlage modular straight cams come with two mouting holes that allow for the cams to be mounted inverted...
The Schlage L-Series uses a clover leaf cam with the exception of the L9060 outside cylinder which uses a straight cam. The cam part number will depend on the type of mortise cylinder, keyway (for ...
Unless otherwise specified on an order, the cam supplied on Falcon mortise cylinders will be the following: Non-IC mortise cylinder is the 5622-STD. IC mortise cylinder is the 5622-IC. Related...
Cams for other applications may be specified with no additional charge, see pricebook.
Chexit devices shipped after 8-24-2015 with motor driven: The Chexit device will use a 1 1/4" mortise cylinder with straight cam. Schlage cylinder 20-001-114 recommended. CAUTION: The length of t...
Chexit devices shipped prior to 8-24-2015:The CX device will need a 1 1/4" mortise cylinder with a straight cam per page 2 of the installation instructions. A 996L-M for a 1 3/4...
 The Schlage ND75 and ND95 locks require the chassis to be assembled and timed correctly for operation.  If the chassis has to be disassembled for any reason please refer to the Assembling Schlage ...
Purchase the L9080 lock case (part number L283-134), switch it with the L9070 case and use the existing trim.
The 30-001 is a conventional mortise cylinder with a clover cam, compression ring and spring for use on rose trim. For use with the L9000 mortise locks except for the L9060 outside cylinder.