Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ sticky door latch ”

Resolution: First, make sure the device is being tested while it is mounted to the door with trim installed. (Testing the device on the bench may show behaviors that will not occur once the d...:

Can Steelcraft doors be prepped for the 98/9949 Concealed Vertical Cable Exit Device?

Resolution: Yes, as an option, Steelcraft doors are available with factory prepared for the 98/9949 Concealed Vertical Cable Exit Device.L, B, CE, T and CE-Series doors are available factory preparedDoor prepa...:

Does an ND50 or ND53 unlock when closing the door?

Resolution: Both the ND50 and ND53 will not unlock when the door is shut. The only way to pop the button is by turning the key on the outside or the lever on the inside. Occasionally custome...:

What would cause an EL device to pull and release?

Resolution: If your Von Duprin EL (solenoid) device pulls and releases quickly instead of holding the latch retracted, please check all of the items below.In most cases, one or more of these solutions will r...:

How do you adjust a door closer?

Resolution: How to: What are the steps to adjust a door closer? Facts: All LCN and FALCON door closers will have 3 regulating valves and a spring adjustment. All closers with a "Del...:

What causes the top latch of a 1690 to not hold in the retracted position while the door swings?

Resolution: The top rod is adjusted too short, so when pushpad is pressed it is not operating the top latch enough to get into the hold down position. The top rod would need to be lengthened by turning the lat...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ sticky door latch ”

RELATED FAQS