Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Sr Swing controller manual ”

RELATED FAQS

Resolution: The 710095-00 (85445-900) and 84570-900 are the older Sr. Swing analog (non-digital) control. It is replaced by the current Sr. Swing digital control box. If you need to replace an old ...:

How do you get the digital read out to light up on the Senior Swing Control Box?

Resolution: There is a total of 4 red buttons on the front of the Senior Swing control box. To turn on the display, press and hold any 2 of the 4 red buttons at the same time for approximately 3-5 seconds. Y...:

What is the part number for the Senior Swing control box?

Resolution: The Senior Swing Series changed to the "Digital" control box in Sept. of 2006.:

Can you use a Senior Swing controller as a replacement for an obsolete Mid Swing controller?

Resolution: The Mid Swing was discontinued Sept. of 2009. The Sr. Swing control box has the power boost feature which the Mid Swing control box did not have. If you replace only the Mid Swing control box...:

Where does the 8310-877 safety sensor attach to the Senior Swing controller?

Resolution: The 8310-877 Bodyguard Safety Sensor attaches (plugs in) to the P1 connector on the Senior Swing controller. The 8310-846 (761462-00) wiring harness "included" with the 8310-877 safety sensor is us...:

How do you install a Senior Swing 9540 on one leaf of a double door?

Resolution: Surface Mounting - A 9542 HDR2 (Double Door Header) and a 9540-18 mounting plate can be used on the active leaf. A manual closer with a PA (parallel arm) can then be installed on the inactive leaf....:

What causes a Senior Swing door to hang open and not close?

Resolution: First, turn off the power to the Senior Swing. If the door closes, check controller for a constant activation signal from an activation device. If door continues to hang up and will not close...:

Why would a Senior Swing door slam shut?

Resolution: The Senior Swing has a built in circuit that controls closing speed through the motor. If the door is slamming, there must be a broken gear in the gearbox and the gearbox will need to be replaced.: