Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
Spindle & Hub Kit
”
RELATED FAQS
Question
Answer
New Design (after May 2018) AD-series and CO-series 993M - Spindle Hub Plate Binding on Mortise Case
Resolution:
In May 2018, the AD-series and CO-series trims were overhauled to a new full-length body design, replacing the old short-body-with-long-plate trim that had been in use since product launch. T...:
How do you remove an AL lock from a door?
Resolution:
AL-Series and discontinued D Lever-Series locks use castle nuts to hold the chassis to the spring cages and to keep the chassis positioned in the door. This causes confusion at times when the lock ...:
Schlage Control FE410 - Interior Lever Retracting Deadbolt, but not Deadlatch
Resolution:
Check the handing plate on the exterior is seated properly. Incorrect installation of the handing plate can cause the spindle to not engage with the interior hub.:
What parts are modified when ordering an ND extended lock?
Resolution:
Only the chassis components are modified for thicker door applications, the lever and spindle assemblies remain intact. The following parts may be modified depending on the function of the lock ...:
Why is the lever binding on LV9000 locks?
Resolution:
Doors that may be slightly under 1 3/4" thick may experience binding. To resolve simply remove the spindle springs and discard. Alternative solution is to install the OSU ferrule kit (L583-347)....:
Will the obsolete Monarch 18 Rim accept the KABA Simplex LP1000?
Resolution:
A special "K Hub" was required for the Monarch 18 Rim device to accept the spindle from the KABA Simplex LP1000. When the Monarch 18 device was obsoleted (2009) the special K hub production e...: