Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ SMALL EXTERIOR ACTUATOR ”

RELATED FAQS

Resolution: Exterior mounting of the 8310-818 series actuators is not recommended. The 8310-818 series actuators are designed to be jamb mounted on the frame. With that installation, the person will have to ...:

What wire gauge is recommended for LCN hardwired actuators?

Resolution: LCN recommends an 18 AWG (minimum) wire size (gauge) to the 8310 Series hardwired actuators.:

What is the part number for a control pin for a 23-030?

Resolution: There are two parts that can be referred to as control pins for a 23-030 (FSIC core).C603-967 is the lower control pin that sits in the seventh hole of the FSIC plug. (part B in exploded view) ...:

Will the 4600 series operator be damaged if activated when the door is locked?

Resolution: Any good secure setup and installation should be getting an open signal that has already gone through credential access first (ex……card reader, keypad, Key switch) and ignoring a locked door. ...:

8310-865 receiver and sequence.

Resolution: RF sequential operation requires the use of of a minimum of 2 receivers (8310-865). Depending on the desired operation required (if using access control), it may require up to 4 receivers (8310-865...:

Which terminals on the 4630/4640 operator are used for activation?

Resolution: The 4630/4640 operator activation inputs are: Normal Activation Inputs (2 parallel) - terminals 16 & 17 or 18 & 19. Sequential Input - terminals 8 & 19. Alternate Action Input - terminals 15 &...:

What could cause a 9100 Series Benchmark operator not to open when the actuator is pushed?

Resolution: If the 9100 Series Benchmark operator does not open when the actuator is pushed: Verify the unit has 120 volts applied to it. Verify the the power light on the control box is on. If not, check ...:

What is a 7910-967?

Resolution: The 7910-967 is a part number for a discontinued RF actuator. It was replaced by the 8310-3856WS RF actuator. The new 8310-3856WS requires the use of an 8310-865 RF receiver. When replacing the ol...:

What is the 7910-956 direct crossover?

Resolution: The 7910-956 actuator direct replacement is the 8310-856 actuator.: