Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ SI reader pro ii ”

Resolution: The MT2 and the Si readers are two different readers. The MT2 is MultiTech reader that can read smart and prox cards on an AD locks. It can only read the encoded sector of Sch...:

What are Si and SiK readers?

Resolution: These are readers for AD locks (can read iclass cards), and work similar to a MT reader. These readers are only offered with a gray or brown finish. They are not metal, so they do not o...:

Will the WPR400 SI reader read Corporate 1000 35 bit smart card?

Resolution: It will read Corp 1000 iClass. If it's MiFare, it will not read the Corporate 1000 side of the card. We cannot read HID MiFare secure sector. :

How do you find the serial number of a biometric F-Series handpunch or Handkey II?

Resolution: Yes, press the * (asterisk) key 10 times on the reader. The serial number will be displayed. A second way of locating the serial number on the reader is to visually check...:

What is the reader address for a master F-Series HandKey II?

Resolution: A F-Series HandKey II can be operated as a stand-alone access control station, as a network master enrollment station, or as a networked access control station which receives and processes co...:

Why did my CO Lock stop working after the Reader Module (electronics) was changed?

Resolution: CO Reader Modules are not individually replaceable, nor can they be swapped between locks. The inside and outside assemblies of a CO lock are a matched/mated set and cannot be swapped to change rea...:

Why is the battery draining so quickly on an AD-Series lock with a Keypad ONLY (KP) credential reader?

Resolution: A Technical Note has been generated to document one method of measuring battery current. See the attachment HERE.:

Can the AD-Series and CO-Series magnetic card credential readers be set to read data from different magnetic card tracks?

Resolution: Customers will need to use the Schlage Utility Software (SUS) on the HHD lock programming device to set the desired magnetic track to be read for access control, if not using default Track 2&n...:

How can I assign individual OSDP ADDRESS to the MT readers?

Resolution: Yes you can, you will need configuration cards for the addressing:Here are the part number for the specific addresses:CE-401-447 OSDP Address 0 (Default)CE-401-448 OSDP Address 1CE-401-449 OSDP Add...:

Can the credential reader be changed on a CO-Series lockset?

Resolution: A Credential Reader MAY be replaced with another Credential Reader of the same type; however, a Factory Default Reset must be performed before the lock will function properly.:

What does error 64 mean on a HandKey II or Handpunch?

Resolution: When you see an Error 64 on a HandKey or a HandPunch, it may mean that the lithium battery is low or there is a disconnect with main board. The first step is to replace the lit...:

Can you connect 2 readers to the CTE?

Resolution: No, CTE can only communicate with 1 reader. :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ SI reader pro ii ”

RELATED FAQS