Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
sense not functioning
”
RELATED FAQS
Question
Answer
Getting message “Adding Failed, Could not connect to accessory” for BE479 Sense
Resolution:
First, perform a Factory Default Reset Next, close the app, turn off Bluetooth (swipe up from the bottom of the screen, tap the Bluetooth icon). Turn Bluetooth back on. Reop...:
Auto-lock feature enabled on Schlage Home App but settings change
Resolution:
Check to see if any virtual keys have been set up allowing administrative permission level. Admin virtual key holders can adjust the setting in the Schlage Home app as well as the original ow...:
BE479 access codes not showing on screen but still working
Resolution:
Power cycle adapter (unplug from wall for 10-15 seconds), remove battery tray. Reinsert battery tray and plug in adapter. Codes will appear:
How do I setup remote wireless access to my Schlage Sense Smart Deadbolt (BE479) with HomeKit?
Resolution:
The Schlage Sense Smart Deadbolt works with Apple HomeKit. That means that remote access is available through HomePod, Apple TV (4th generation ), or iPad (iOS 10.0 or higher). Your chosen Apple ...:
How do I manually program the AD300 RS-485 Address?
Resolution:
Manually Setting the RS-485 Address This method is only available before the first network communication between an Access Control Panel (ACP) and the lock. Do a Level 1 and Level 2 Factory De...:
What will happen if the voltage on an L lock goes above the 26V maximum range?
Resolution:
Applies to L9090EL/EU, L9091EL/EU, L9092EL/EU, L9093EL/EU, L9094EL/EU, L9095EL/EUOvervoltage will cause the lock to shut down for approximately 5 minutes to allow the circu...:
What would cause a 4600 operator to click a few times when the actuator is pushed, but not open the door?
Resolution:
If a 4600 clicks, but won't open the door: Verify proper connection of all the control box connectors. Verify correct manual operation of door. Verify actuator connections and any strike/maglo...:
Why does the PS900 power supply not provide any DC output when AC power light is on?
Resolution:
The following items may cause the PS900 series power supply to have no DC output voltage. 1. If the DC voltage selection jumper is missing, the power supply will not provide any D...:
My PS914 has power but my 2RS card is not working?
Resolution:
Following could cause the 900-2RS board not to operate: If 900-2RS board is not plugged into the PS914 mother board. If PS914 power supply is selected for 12VDC instead of 24VDC. If control co...:
How do I get service on my Astro Swing operator that isn't working properly?
Resolution:
LCN does not does not have or supply any information for the old (obsolete) "High Energy" Dor-O-Matic Sliding doors, Bi-Fold doors or Astro Swing doors. You MUST be AAADM certified to work on, or g...:
D73 locking issues with push button.
Resolution:
A design change occurred in 2001 to address a locking/unlocking issue with the discontinued D73 lever locks. This included modifying the cam and plug, spindle and using a different plung...:
What is a 7910-967?
Resolution:
The 7910-967 is a part number for a discontinued RF actuator. It was replaced by the 8310-3856WS RF actuator. The new 8310-3856WS requires the use of an 8310-865 RF receiver. When replacing the ol...: