Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
schlage cylinder trim ring
”
RELATED FAQS
Question
Answer
What cylinder is used for the Falcon 510L and 510L-NL trim?
Resolution:
The Falcon Monarch 510L and 510L-NL trim will accept either a 1 1/4" Mortise cylinder with a straight cam or a 1 3/8" Mortise cylinder with a straight cam using the blocking ring provided with the ...:
What are the part numbers for the Schlage blocking rings?
Resolution:
After selecting the correct blocking ring, specify the thickness. The table below shows the different thicknesses that the rings are offered in. &...:
What is the part number for the blocking ring for use without compression ring?
Resolution:
The part number for a Schlage mortise cylinder blocking ring for use without compression ring is the 36-079 (specify dimension and finish).:
Which way is the tail piece of the rim cylinder is inserting into the Von Duprin 98/99 rim device from 996L trim?
Resolution:
The tailpiece of the rim cylinder can be inserted into the Von Duprin 98/99 rim device either vertical or horizontal (using the tailpiece guide).:
What keyway comes with the Falcon 19-KIL?
Resolution:
The standard cylinder keyway that comes with the 914KIL trim is a Schlage 6 pin "C" section.:
How does the 98-2 or 99-2 double cylinder function affect the outside lever trim?
Resolution:
Double cylinder (-2 or -2SI) features an inside key cylinder which locks or unlocks the outside trim and an outside key cylinder which retracts the latch bolt only (Night latch function). Thi...:
What cylinder is needed when using the 9975L with 996L-M trim?
Resolution:
A 1 1/4" mortise with straight cam similar to the Schlage B502-191 is needed when using Von Duprin 9975 mortise device with 996L-M trim.:
What cylinder is used in a 210K trim for the 22 series exit device?
Resolution:
Equivalent to the Schlage D series line with a C keyway. Part number 21-002.:
What type of cylinder does theVon Duprin 373L trim take?
Resolution:
All Von Duprin 370 Series trims require a 1 1/4" mortise cylinder with a straight cam.:
Why is the key locking and/or unlocking my E996L for a 9875?
Resolution:
The 7500 mortise lock should be configured for NL function as shipped not as Classroom. See figure 4-3 in E996L instructions.: