schlage co lock installation instructions


The center line of the L9000 mortise lock is 7/8" above the center line of the 6211 electric strike. This is the "C" dimension given on the second page of the 6211 template.
This information can be found at the following URL's: AD200/AD250/AD300/AD400 Cylindrical P516-092.pdf
AD200/AD250/AD300/AD400 Mortise P516-093.pdf
AD200/AD250/AD300/AD400 Cylindrical Exit P516-094.pdf
AD200/AD250/AD300/AD400 Mortise Exit P516-095.pdf
CO100/CO200/CO250 Cylindrical P516-266.pdf
CO100/CO200/CO250 Mortise P516-267.pdf
CO-Series Cylindrical Exit P516-268.pdf
CO-Series Mortise Exit P516-269.pdf
To remove the Schlage L Series from a door reference the appropriate installation instructions found here at
 See the attached Technical Note for instructions on saving a "Device Template" FROM a device or loading TO a device, Device Template Tech NoteOn the SUS/HHD go to the LOCK Properties tab, and sele...
The Schlage AL-Series SFIC locks require one (1) small format spacer (D500-000) for 7-pin cores and two (2) small format spacers for 6-pin cores.  When these spacers are not ins...
For W lock levers, you can choose whether or not to install the mounting posts.  This will also affect how the door is prepped so be sure to determine how you will install the locks befor...
The JD YA6 tailpiece is intentionally designed such that the tailpiece cannot be installed at the same time as the cylinder.  Interchangeable cylinders assume that the lever and taipiece is in...
See the JD Yale Lever installation instruction HERE