Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ push side closer handing ”

Resolution: Optional closer reinforcements are located at 3" from hinge jamb to the beginning of the reinforcement plate. This applies to Regular Arm, Parallel Arm, Top Jamb. Regular Arm (RA) closer reinfor...:

Is the 4111 closer handed?

Resolution: The 4110 closer is handed, and will have an "RH" and "LH" on the casting next to the closer shaft. The regulating valves are going to be on the same side as the hand of the closer.:

Does the old style 4030 have the same templating as the new style 4031?

Resolution: The old 4030 series was: Handed Mounted regular arm hinge side. Had sized springs, were not adjustable. The 4033 is an obsolete closer. If required, handing can be verified by looking at ...:

How do I determine the hand of a door?

Resolution: Go to the push side of the door opening. See above illustration. If door swings out to the left, it needs a left hand door closer. If door swings out to the right, i...:

What are Hold Open Closers & Magnets?

Resolution: Hold Open Closers & Magnets (Fire/Life safety products) provide a wide range of solutions. Single or multi-point hold open closers Utilize an electromechanical closer. Hold the door o...:

What is the difference between an LCN CUSH arm, and an LCN EDA arm?

Resolution: EDA ARM - The EDA arm is a heavy duty parallel arm mount. The degree of door opening is determined by the template used for mounting. EDA arm closers can only be mounted as a Push Side parallel ar...:

Can a pull side mounted 1460 open 180°

Resolution: A 1260 Pull Side can be mounted standard template for 180°, frame and trim permitting.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ push side closer handing ”

RELATED FAQS