Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ power supply el and ept ”

RELATED FAQS

Resolution: The 8200 can not supply the power needed on an EL dev ice. The EL device requires a Von Duprin PS914-2RS or PS914-4RL power supply or the older Von Duprin PS873-2 or PS873-4TD models.:

What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?

Resolution: :

What is needed to keep the EL device retracted all day?

Resolution: To keep the Von Duprin electric latch retraction EL or QELA exit device dogged (retracted) all day, have your access control, Key pad, key switch, fire alarm contact or any other signals ...:

What is the power supply needed for the Dor-O-Matic EL devices?

Resolution: PS914 with either the 900-2RS option board for powering 1 or 2 devices or the 900-4RL option board for up to 4 devices.:

What could cause the fuse to blow in a PS873 power supply?

Resolution: Following could cause the fuse to blow in Von Duprin PS873 power supply. PS873 power supply provides 2AMP at 24VDC or 4AMP at 12VDC. If this limit is exceeded the fuse will blow in the power sup...:

What size wire and run is recommended when using a PS914-2RS?

Resolution: For Product Shipped Prior to August 2012 using the old (black) potted module:a. 0-100 ft 14 gauge wireb. 0-200 ft 12 gauge wire&nbs...:

What power supply is needed for EL devices?

Resolution: You can use a Von Duprin PS914 power supply with any of the following option boards depending on the application. 900-2RS board will power 1 or 2 devices that do not require timing from pow...:

What is the purpose of the 900-2RS board?

Resolution: The 900-2RS option board is used with PS914 power supply to isolate the inputs such as key pads or card readers from the outputs for EL electric exit devices. The EL draws 16 amp inrush that needs...:

How many Von Duprin QEL devices can be connected to a power supply?

Resolution: Product Ordered before 7/10/2012 - Product identified by no label on QEL motor. You must use the 900-2Q option board with the PS900 power supplies to operate the QEL devices. The attached ta...:

Is there a wiring diagram for EL and Von Duprin PS914-2RS power supply?

Resolution: Reference The 914 Installation instructions.:

What power supply is required for two EL devices and one LCN auto operator?

Resolution: Von Duprin PS914 x 900-4RL supports two EL with two auto operator.:

Is the 900-ELK wiring adaptor required when using the PS914 power supplies?

Resolution: Products shipped on or after August 8, 2012 no longer require the EL wiring adaptor. The ELK Wiring Adaptor (900ELK) was used only when using the PS914 power supply with either the 900-2RS or...:

What power supply is need for Falcon EL devices?

Resolution: The Von Duprin PS914 power supply with either the 900-2RS or the 900-4RL option board is required.:

What is the power output of a 4600 operator?

Resolution: The 4600 Series operator has both a 12VDC and 24VDC output rated at 1A (combined load) to power strikes, maglocks, and other devices, but an EL device must have a separate Power Supply for motorize...:

What gauge wire is needed for CX red and black power wires?

Resolution: For Product Shipped prior to 8-24-2015 with solenoid and EPT or Door Loops: a. 0-100 ft, use #14 Gauge Wire ...: