Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ power requirements for EL ”

Resolution: For Product Shipped prior to 8-24-2015 with solenoid and EPT or Door Loops: a. 0-100 ft, use #14 Gauge Wire ...:

Is the PS 914-2RS required for EL operation?

Resolution: The PS914-2RS is the required power supply to operate 1 or 2 EL devices.:

Can the 8200 Series operator power a electric strike?

Resolution: The 8200 Series operator CANNOT power a strike, maglock, or EL device. A separate power supply is ALWAYS required. There is an onboard relay to control a strike, maglock, or EL device.:

What is the power output of a 4600 operator?

Resolution: The 4600 Series operator has both a 12VDC and 24VDC output rated at 1A (combined load) to power strikes, maglocks, and other devices, but an EL device must have a separate Power Supply for motorize...:

Will the MPB-842 or MPB-840 power EL or QEL devices?

Resolution: The old MPB842 power supply will power up to two EL electric panic bars but will not power the QEL devices. A defective potted module inside the electric panic bar or defective power supply coul...:

What power supply is needed for EL devices?

Resolution: You can use a Von Duprin PS914 power supply with any of the following option boards depending on the application. 900-2RS board will power 1 or 2 devices that do not require timing from pow...:

Can we run both mag locks and EL devices from the PS 914?

Resolution: It requires 900-4RL and 900-FA option boards to release the mag locks when a fire alarm is activated. Specify PS914 x 900-4RL x 900-FA.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ power requirements for EL ”

RELATED FAQS