Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ power requirement for EL device ”

Resolution: For Product Shipped prior to 8-24-2015 with solenoid and EPT or Door Loops: a. 0-100 ft, use #14 Gauge Wire ...:

What power supply is needed for EL devices?

Resolution: You can use a Von Duprin PS914 power supply with any of the following option boards depending on the application. 900-2RS board will power 1 or 2 devices that do not require timing from pow...:

What is the power output of a 4600 operator?

Resolution: The 4600 Series operator has both a 12VDC and 24VDC output rated at 1A (combined load) to power strikes, maglocks, and other devices, but an EL device must have a separate Power Supply for motorize...:

Is the 900-ELK wiring adaptor required when using the PS914 power supplies?

Resolution: Products shipped on or after August 8, 2012 no longer require the EL wiring adaptor. The ELK Wiring Adaptor (900ELK) was used only when using the PS914 power supply with either the 900-2RS or...:

What power supply is required for two EL devices and one LCN auto operator?

Resolution: Von Duprin PS914 x 900-4RL supports two EL with two auto operator.:

Can the 8200 power an EL panic device?

Resolution: The 8200 can not supply the power needed on an EL dev ice. The EL device requires a Von Duprin PS914-2RS or PS914-4RL power supply or the older Von Duprin PS873-2 or PS873-4TD models.:

What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?

Resolution: :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ power requirement for EL device ”

RELATED FAQS