Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
new von dupri push
”
RELATED FAQS
Question
Answer
Why does my Chexit device open without sounding the alarm?
Resolution:
:
Why is the Von Duprin exit alarm ALK going into alarm on it's own?
Resolution:
The following may cause the ALK to go into alarm: Make sure red and blue wires on the RX switch are connected to the exit alarm ALK terminal block and yellow wire is taped off. Check the red an...:
Is there any way to lock the push side of an opening with a Von Duprin exit device?
Resolution:
You cannot lock the push side of the exit device as a panic device by design must allow exit. Any attempt to block an exit is forbidden by code.:
What could cause a 9100 Series Benchmark operator not to open when the actuator is pushed?
Resolution:
If the 9100 Series Benchmark operator does not open when the actuator is pushed: Verify the unit has 120 volts applied to it. Verify the the power light on the control box is on. If not, check ...:
If I convert from the Von Duprin 88 K (88 rim with 880K trim) to the 373 L trim is a new back plate required?
Resolution:
No, the back plate for 880K-knob trim is the same as for 373L-lever trim. However, since 373L is a narrow style trim, an 889 cover plate is required: part number is “889.finish”:
What replaces the Von Duprin PS873 power supply?
Resolution:
Option Board Von Duprin PS914 Schlage PS902, PS904, PS906 900-2RS Yes No 900-2Q ...:
Can the Von Duprin 996L lever handle be replaced with a new one?
Resolution:
Yes, Von Duprin 996L lever handle can be replaced with a new one . Attached installation instructions shown how to replace the existing lever handle on 994/996L trim for rim and vertical rod device...:
How do you change the Von Duprin 990TP trim to NL function?
Resolution:
Recommend to order a new 990NL-R/V or M trim to change from TP/Classroom function to NL/Storeroom function. You will also need to reinstall the NL drive screw back into into the mast...:
Can the handing be changed on a Von Duprin 373L trim ?
Resolution:
Changing the handing on a Von Duprin 373L trim requires following parts: LHR to RHR requires 090092 ( Package of 4 springs ) and 050597 ( back plate assembly ). RHR to LHR requires 090091 ( Pa...:
How do I change the handing on the Von Duprin 373L trim?
Resolution:
Changing the handing on a Von Duprin 373L trim requires following parts on all lever designs EXCEPT #12: RHR requires part number 090092-00 (LEVER CONTROL SPRING RHR PKG/4) and 050597-...:
What is the replacement for the Von Duprin 7321 keypad?
Resolution:
The VD 7308/7311/7321/7322 were replaced by the KP212 Von Duprin 7311 and 7321 key pads were discontinued and there are not direct replacements Von Duprin no longer sells key pads, contact Schl...:
Are the Pushbar Retrofit Kits (PBKIT) the same for 98/99 and 33A/35A series devices?
Resolution:
A PBKIT is a Pushbar Retrofit Kit.The pushbar retrofit kits are not the same for 33A/35A and 98/99 series exit devices. Depending on the finish of the exit device, the pushbar end caps are di...: