Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ low energy operator ”

RELATED FAQS

Resolution: Automatic Operator, Auto Operator, Power Operator:

Why would a Falcon 8200 Series operator be blowing the fuse?

Resolution: If the Main AC fuse is blowing, the control box is defective and needs to be replaced. The "Main Fuse" is a (5x20MM) 1 Amp Slow Blow fuse. If the 12VAC fuse is blowing, verify they are not trying...:

How do I get service on my Astro Swing operator that isn't working properly?

Resolution: LCN does not does not have or supply any information for the old (obsolete) "High Energy" Dor-O-Matic Sliding doors, Bi-Fold doors or Astro Swing doors. You MUST be AAADM certified to work on, or g...:

What power operator is recommended/used for occasional activation with mainly manual traffic?

Resolution: The 4630/4640 Series operator is designed/recommended for a door that will see mostly manual traffic with the occasion automatic/ handicap operation.:

What is the difference between the Senior Swing 9540 and 9530 Series power operators?

Resolution: The 9542 is the single door operator that mounts on the "push side" of the opening with a REG arm. The 9531 is the single door operator that mounts on the "pull side" of the opening with a STD arm...:

What is the input / output of the 8200 series operator?

Resolution: The Falcon 8200 series operator requires a input of 120 VAC @ 1 Amp.:

What would cause a Senior Swing to open too far?

Resolution: The Senior Swing operator is designed to power open the door to 90°. The built in dead stop (in the gearbox) prevents it from opening any further. If the Senior Swing operator is opening to far (pa...:

What are the power requirements of the 4600 series operator?

Resolution: The 4600 series operator requires a 120 VAC @ 1.5 Amp power input to be field connected. Hardwiring is always recommended, but a "plug-in" line cord can be installed (by others) with the proper cor...:

What is the power output of a 4600 operator?

Resolution: The 4600 Series operator has both a 12VDC and 24VDC output rated at 1A (combined load) to power strikes, maglocks, and other devices, but an EL device must have a separate Power Supply for motorize...: