Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ lever height from floor ”

Resolution: Required top and bottom rod adjustment. Top rod possibly is adjusted too short and not lifting the rod far enough to engage the latch retention which would cause bottom rod to drag floor ...:

Does LCN or Dor-O-Matic still make a floor closer?

Resolution: Neither Dor-O-Matic or LCN manufacturers a floor closer. :

Does Von Duprin have a fire latch that will go into the floor?

Resolution: Auxiliary fire latch is tested only from door to door latching by Von Duprin. Some door manufacturers have tested our devices LBR and use additional fire latches to pass the fire test. Contact the ...:

What height should a lock or deadbolt be installed?

Resolution: According to ANSI specifications for cylindrical or mortise locks: The lock strike centerline should be 40 5/16" from the bottom of the frame with the lock in relation to the strike.&...:

What are the ANSI recommendations for the actuator mounting height and distance between the wall actuator and the door opening?

Resolution: Always check the most current revision of the ANSI A156.19 standard for recommendation or requirement of the location of a Knowing Act switch. 2019 ANSI A156.19 states the requirement of the ...:

Will the new concealed vertical cable system work with any door height?

Resolution: :

What are the standard door and frame clearances?

Resolution: To determine Actual Door Size, the following values are subtracted from nominal door size (frame opening/order size) Actual Door Size: The largest measured width by height of the door leaf as m...:

What are the dimensions on the LAT and LON levers?

Resolution: See dimensions for LAT and LON levers from the L9000 series :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ lever height from floor ”

RELATED FAQS