Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ L Series power wire and gauge requirements ”

RELATED FAQS

Question
Answer
What gauge wire is needed for a CX device?
For devices shipped after 8-24-2015 with motor driven:  a.       0-200 ft, use  #18 gauge wire b.      0-500 ft, use #14 gauge wir...
For Product Shipped prior to 8-24-2015 with solenoid driven:          a.       0-100 ft, use #14 Gauge Wire      b.&n...
What is the wire gauge on the motor driven L9000 mortise locks?
Supply wires - 24AWGRX wires - 20AWGLX wires - 20 AWG
What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?
  For Product Shipped Prior to August 2012 using the old (black) potted module: a.       0-100 ft 14 gauge wire b.      0-200 ft 12...
 
What are the wire gauge and length requirements for QEL devices?
Use #18 gauge wire up to 200 feet maximum distance from PS900 x 900-2Q power supply to the QEL exit device. The new QEL+ no longer requires the 900-2Q board but still needs a different option board...
What is the maximum distance you can wire a PIB300 or PIB301 from a Access Control Panel?
The PIB300/PIB301 should be located as close as possible to the Access Control Panel.  Do not exceed 500 feet.
Wiring distance from the PIB300/301 to the AD300/301 locksets may be up to 1000 feet (18AWG) for Power and up to 4000 feet (24AWG) for the RS485 data lines.
See the User Guide instructions in the links below
What is the difference between the EPT 2 and the EPT 10?:
The EPT2 has (2) 18 gauge wires and the EPT10 has (10) 24 gauge wires.  Even though they are 18 gauge or 24 gauge wires they are special high stress, high flex, & high current wires specifically u...