Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ jamb mounted actuator diagram ”

RELATED FAQS

Resolution: Exterior mounting of the 8310-818 series actuators is not recommended. The 8310-818 series actuators are designed to be jamb mounted on the frame. With that installation, the person will have to ...:

What are the ANSI recommendations for the actuator mounting height and distance between the wall actuator and the door opening?

Resolution: Always check the most current revision of the ANSI A156.19 standard for recommendation or requirement of the location of a Knowing Act switch. 2019 ANSI A156.19 states the requirement of the ...:

Can a Glynn Johnson 90 stop be used with a top jamb mounted 4040?

Resolution: A 4040-18G drop plate will be needed to drop the closer and arm down far enough not to conflict with the GJ 90 series overhead stop.:

What are Pneumatic Automatic Operators?

Resolution: Pneumatic Automatic Operators are used in areas where electrically operated devices are not convenient or permitted. Consists of a modified, heavy-duty door closer for manual oper...:

Can a 4041 EDA be mounted top jamb?

Resolution: The 40401/4040XP closer with optional EDA arm has to be mounted parallel arm on the push side of the door.:

What actuators can be used on the 8310-866 Bollard post?

Resolution: The LCN Bollard post (8310-866) only accepts the "square" actuators (no round actuators). The size of the Bollard post is 4” X 6” X 36”. Acceptable actuator part numbers are: Hard Wired - 831...:

Will the 8310-853 actuator mount in a single gang or a double gang box?

Resolution: The 8310-853 (T) series actuator will mount to either a single or double gang electrical box.:

What is the difference between an LCN CUSH arm, and an LCN EDA arm?

Resolution: EDA ARM - The EDA arm is a heavy duty parallel arm mount. The degree of door opening is determined by the template used for mounting. EDA arm closers can only be mounted as a Push Side parallel ar...:

What components are needed to convert a hard wired actuator button to a wireless actuator button?

Resolution: To convert an RF actuator button to a hard wired actuator button, simply remove the RF transmitter an connect the hard wiring to the "Common" and "Normally Open" terminals on the the switch.:

What is the Buy American Act (BAA)?

Resolution: BAA/ARRA stand for Buy American Act and American Recovery and Reinvestment Act. A brief description of some of the federal requirements can be found in the BAA Catalog on the Allegio...: