Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
IVES EDGE DUARD
”
RELATED FAQS
Question
Answer
Where is the catalog information and specifications on the Ives edge guards?
Resolution:
Information for Ives edge guards can be found on pages B51-B53 of the Ives Catalog linked here, and in the edge guard ordering guide linked here.:
What is the model number for the Ives door edge pull?
Resolution:
The sliding door edge pull is part number 230.:
Do the Von Duprin 5654 and 5754 mullions have edging that accepts weatherstripping?
Resolution:
The 5654 and 5754 mullions have mullion edging that accepts weatherstripping. The weatherstripping is included with both mullions and is already attached to the mullion edging on new 5654 and 57...:
Can a 1 3/4" thick panel be used in a fire rated transom frame with a transom bar?
Resolution:
Transom panels are available in the following constructions: 1 3/4" thick panels with interior construction similar to an L-Series door installed into a frame either Without a transom bar - r...:
Door hitting the strike jamb?
Resolution:
If the door hits the frame (or rubs on the rabbet of the head or jamb) the frame is out of square and improperly installed. Door edge rubbing on the rabbet - shimming the hinges may resolve the...:
Why doesn't full rotation of the AD or CO Series Exit Trim (993) outside lever fully retract the Von Duprin 98/99 Exit Device latch?
Resolution:
- AD Series and CO series products require that the Night Latch (NL) screw is installed in the exit device. Be sure this screw is installed- Exit hardware and strike must be properly mounted ...:
What is the minimum dimension from the edge of the door to a glass light cutout?
Resolution:
Minimum dimensions to cutouts for glass lights: Vertical edge of door to edge of cutout = 5 29/32" Top of door to top of cutout = 6" Bottom of door to bottom of cutout = 10" Reinforcing chann...: