Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
intermittent continuous locknetics
”
RELATED FAQS
Question
Answer
Locknetics LP150/250 Power Supplies - Wiring in Fire Alarm
Resolution:
Wire the Fire Alarm panel back to the “Control In” terminals on the Power Supply. It needs to be a Normally-Closed dry contact from the Fire Alarm. :
Locknectics EGB-100 and UL Listing
Resolution:
As of October 2020, the EGB-100 has no UL Listing or rating.:
Warranty information on Allegion Commercial products.
Resolution:
See here for our Warranty Information. :
Isonas RC03 with Intermittent Connection / Drop
Resolution:
If RC-03 Classics, set the port speed to 10mb / half-duplex, disable autonegotiate. If RC-03 Coldfire, set the port speed to 10mb / full-duplex, disable autonegotiate. Also. these devices...:
What would cause a 4600 Series operator to open up and intermittently stick open?
Resolution:
If manually it opens and closes fine, check to make sure one of the actuators is not getting stuck in the on position. Verify that the "Operating Indicator" LED's -- "POWER and SAFETY CLEAR" LED's ...:
Locknetics DKP-NS Keypad - Removing Single User PIN
Resolution:
The keypad does not allow for the removal of specific user pin codes, you can only overwrite them using step 2A in the user guide (here).:
What is a locknetics 268/24-10 dual mag functionally equivalent to?
Resolution:
Functionally equivalent to a schlage 350+ which is functionally equivalent to a M450:
Locknetics Electric Strikes on Double Door Applications
Resolution:
It is possible to do, but not advised or supported. The door thickness would have to be enough to accommodate the strike body, then power ran to the strike with an EPT, electri...:
What is the replacement for the Locknetics 9100 series electric strike?
Resolution:
The Locknetics 9100 series electric strikes are replaced with Von Duprin 6211 and 6210 electric strikes. The 6211 is used if the frame is being replaced. The 6210 is for ...:
Locknetics NC450 Strike and Fire Rating
Resolution:
As of October 2020, the NC450 does not have any specific fire rating.:
Locknetics WRT-K - Communication Range
Resolution:
The 900 MHz range between the transmitter and the receiver for the WRT-K 2 relay with logic module is 300 ft over direct line-of-sight. If there is anything in the between the transmitte...:
What touch bars are available under the Locknetics brand?
Resolution:
TB-36 Touch bar - 36" door 628 FINISH TB-42 Touch bar - 42" door 628 FINISH TB-48 Touch bar - 48" door 628 FINSH :
Is there a way to test signal strength on Locknetics WRT-K wireless receiver?
Resolution:
Yes- Pressing and holding transmitter button for three (3) seconds activates signal strength LED on remote fob Signal Strength Indicator- LED COLOR DESCRIPTION GREEN strong wireless si...:
Locknetics MLBK600 Physical Dimensions
Resolution:
9-7/8" x 1-7/8" x 1-3/16” :
How do I program Locknetics CM / CL legacy locks with the Schlage Utility Software (SUS) and Hand Held Device (HHD)?
Resolution:
- With the CIP NOT inserted and the Schlage Utility Software (SUS) running o Enter the Master Programming PIN or Present Loc...: