Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
IC TAILPIECE FOR LEVER HANDLED CLASSROOM LOCKS
”
RELATED FAQS
Question
Answer
Will Falcon B locks prepped for BD accept a 6 or 7 pin core?
Resolution:
The B series accepts 6 or 7 pin small format cores when specifying with the "BD" cylinder suffix (less small format interchangeable core). The tailpiece shown below is used for bo...:
When ordering the ND lock less cylinder will it come with a tailpiece?
Resolution:
The Schlage ND is shipped with a driver/tailpiece when ordered with a LD, BD, or JD suffix.:
What is the part number for the SFIC tail piece for a W lock?
Resolution:
Q330-168 SFIC Tailpiece (throw member for levers) Q330-169 SFIC Tailpiece (throw member for knobs) :
How do I change the function of the Von Duprin 7500 mortise lock from Lever ( classroom ) to NL ( night latch )?
Resolution:
To convert the Von Duprin 9975L to 9975NL exit function follow these steps (Note: the mortise lock is shipped as Night Latch from the factory): Turn the NL screw on 7500 mortise lock counter clo...:
Can I get the T series with a Schlage Full Size Interchangeable core?
Resolution:
The T lock can accept a Schlage Full Size core, but the cylinder suffix must be specified as "J IC-SC" so the correct parts are supplied (including the tailpiece) Example: T581J IC-SC:
What is the part number for T lock tailpiece used with a conventional cylinder?
Resolution:
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders. Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces:
Why does my AD or CO series lock unlock when the lever is raised?
Resolution:
Installers have reported that their AD-CO Series cylindrical or mortise locks will unlock whenever the outside lever is lifted. This will occur if the outside spindle (square post) is install...:
Why can't I get my JD YA6 cylinder to install into an AD-Series lock?
Resolution:
The JD YA6 tailpiece is intentionally designed such that the tailpiece cannot be installed at the same time as the cylinder. Interchangeable cylinders assume that the lever and taipiece is i...: