Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ exit device latch half way ”

Resolution: The Falcon T series was discontinued August 12th, 2026 and was replaced by the Falcon TM series. For T locks shipping mid-June 2013, the new latch can be identified by viewing the deadlatch pr...:

How do I wire an EL device to normally hold open the latch and release it during a fire alarm?

Resolution: Use a normally closed fire alarm as the input to the power supply option board (PS873-2 or PS914-2RS), this will hold the latch retracted. During a fire alarm, the contact will open, dropping...:

What would cause an EL device to pull and release?

Resolution: If your Von Duprin EL (solenoid) device pulls and releases quickly instead of holding the latch retracted, please check all of the items below.In most cases, one or more of these solutions will r...:

Warranty information on Allegion Commercial products.

Resolution: See here for our Warranty Information. :

What power supply is needed for EL devices?

Resolution: You can use a Von Duprin PS914 power supply with any of the following option boards depending on the application. 900-2RS board will power 1 or 2 devices that do not require timing from pow...:

Why doesn't full rotation of the AD or CO Series Exit Trim (993) outside lever fully retract the Von Duprin 98/99 Exit Device latch?

Resolution: - AD Series and CO series products require that the Night Latch (NL) screw is installed in the exit device. Be sure this screw is installed- Exit hardware and strike must be properly mounted ...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ exit device latch half way ”

RELATED FAQS