Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ exit device installation ”

Resolution: Recommendation is to use mild soap with a damp cloth to clean an exit device.:

Can the 9927 exit device be installed Less Top Rod?

Resolution: The top rod is required for proper operation. The top latch controls both the top & bottom rods and without the top latch/rod the bottom latch would release when pushpad or trim was used but then ...:

How far down can an exit device be cut down in the field?

Resolution: For most exit devices, please refer to the specific device series catalog for minimum door opening width the device can be cut down to fit. Be aware that some device options, frame...:

Is there a template that shows where to drill the hole for E/EL/SS/RX/LX/CX wires?

Resolution: The hole should be drilled in the field once the end cap is located on the door. It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...:

What is SLM blocking and how does it effect exit device installation?

Resolution: SLM - special laminated material - blocking is put into the wood doors so there is material to mount the exit device using wood screws.:

Do we make a blank trim plate to replace an existing trim?

Resolution: We have several blank trims listed in the price book to cover existing trim prep in door. DEVICE EO TRIM 22 230EO 88 880EO 98/99 990EO or 996EO* 33A/35A Rim, 33/3...:

Where do I install my Auxiliary Fire Latch (AFL) in a Less Bottom Rod, Fire Rated (LBR-F) exit device?

Resolution: Installation should be 6" from bottom of the door. See attached templates as reference. T-5494 for HM Doors W-5494 for Wood Doors:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ exit device installation ”

RELATED FAQS