Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ equal rabbet door frame ”

RELATED FAQS

Resolution: Lead lined frames are intended for use in the X-ray Room locations in Health Care facilities. Frames are provided by Steelcraft prepped as follows: Frames are supplied knock-down (KD). Fram...:

Can Steelcraft make a 12 gage hollow metal mullion?

Resolution: Steelcraft does not manufacture 12 gage closed section mullions. The maximum is 14 gauge. Steelcraft can provide the outer perimeter (open sections only) of a transom frame in 12 gage material. ...:

DOUBLE RABBET FRAME

Resolution: Frame with a recess or offset formed on both sides of a stop to receive a door:

Will 1 7/16" thick glass require a special rabbet size on borrowed light frames?

Resolution: Yes. 1 7/16" thick glass but a special rabbet size is required. The size of rabbet required for the frames would depend on the size of the glazing bead being used. For 1" wide glazing stops, ...:

What is the standard downsizing for a door leaf when using continuous hinges?

Resolution: Doors require special downsizing for continuous hinges. The amount of downsizing depends on the hinge specified (manufacturer and type) and the hinge application (Full Mortise versus Full Surface v...:

Where is the Fire Label located on a door and a frame?

Resolution: Fire labels (UL, ITS/WHI or FM) are located as follows: Butt Hinges and Pivots: On the doors the fire label is located on the hinge edge between the top and 2nd hinge preparation. On the fram...:

Door hitting the strike jamb?

Resolution: If the door hits the frame (or rubs on the rabbet of the head or jamb) the frame is out of square and improperly installed. Door edge rubbing on the rabbet - shimming the hinges may resolve the...:

DOOR RABBET

Resolution: Rabbet, frame feature; Frame Profile?:

What is the hinge backset for 1 3/4" thick door?

Resolution: Hinge backset is the dimension from the leading edge of the hinge to either the stop on the frame or to the stop face (push side) of the door. For operating clearance, the hinge backset on the d...:

What are the standard door and frame clearances?

Resolution: To determine Actual Door Size, the following values are subtracted from nominal door size (frame opening/order size) Actual Door Size: The largest measured width by height of the door leaf as m...: