Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
EPT mounting location for door with offset pivots
”
RELATED FAQS
Question
Answer
Can a 450 overhead be used on a 48" wide door hung with butt hinges or offset pivots?
Resolution:
The 455 can be mounted on a 48" wide door, but we cannot guarantee that it will withstand the forces involved. Recommend using 906 instead.:
Can a 4600 operator be mounted with pivots?
Resolution:
On a single door take the mounting dimensions from centerline of pivots. On a pair of doors, depending on the door width and pivots being used, the operators can butt up against each other or ov...:
How do you order a Senior Swing header for a 2810 on one leaf and a 2010 on the other?
Resolution:
LCN does offer a 2810 Senior Swing / 2010 manual closer combo for a pair of doors. Both units contained within the same Senior Swing header. To order a paired operator with a 2810 o...:
Where is factory recommendation for location of an EPT?
Resolution:
EPT installation guidelines are as follows: Recommended location is 6" below top hinge per template Steelcraft will locate the power transfer prep at the Von Duprin re...:
Do we have a maximum door width or height for using pivots?
Resolution:
The maximum door width that pivots have been tested is a 4' wide door. Any door greater than 4' would shorten the life of the pivots. There is no maximum door height, for offset pivots the ru...:
What are the minimum header lengths for a Senior Swing?
Resolution:
The minimum header lengths for a Senior Swing with standard Spindle centers are:Concealed 2810 Series:2811 single door (offset pivot or butt hinge) -- 33".2811 single door with stop (cent...:
What mounting options are available with the 2030 Series closer?
Resolution:
The 2030 Instructions included with the unit has templates for mounting with standard butt hinges, center pivots, and offset pivots.: