Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Enable lock and leave ”

Resolution: Or force a strike input to the PIM400-TD2. Short J8-1 and J8-2 (Door 1), Short J7-1 and J7-2 (Door 2) on the PIM400-TD2:

Lock and Leave

Resolution: The Lock & Leave Feature is a feature that when enabled, the lock can be re-locked from the outside of the door for a short period of time.:

Can the low coin cell Nuisance delay be Disabled on a CO200?

Resolution: The coin cell is ignored when the lock sets are used with Manual Programming ONLY or while in Construction mode.:

How do I manually change PIN length on an AD200?

Resolution: Beginning with Firmware Packages ADFwPkg 2.16.3 and COFwPkg 1.20.0 the PIN length can be manually changed for AD200 and CO200 locks as follows: 1. Press {programming code (default is 97531)} then ...:

How do you reset an AD-200 back to default?

Resolution: :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Enable lock and leave ”

RELATED FAQS