Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ door postion switch ”

Resolution: A Door Position Switch is a switch and magnet mounted on the door and frame that monitors the door status. If door is held open beyond rearm time or if door is forced open, alarm wil...:

Will CX re-arm if door is held open?

Resolution: If a door position switch (DPS) is connected across the green and white wires of the old CX (green and red of new CX) the CX would go into alarm if the door is held open when it attempts to rearm.&...:

AD changing Function in the field

Resolution: -On the AD series offline locks only you can change the lock function from Classroom/Storeroom to a Privacy, office or apartment function out in the field. - This is done via the HHD/SUS using...:

Why does the arm of my 4110 EDA touch the door when it is closed?

Resolution: If the closer arm is touching the door, it is because the arm or the closer body is not templated correctly. Confirm dimensions are taken from the proper location and make corrections if needed. :

Why would a 4600 not open a full 90 degrees?

Resolution: A 4600 (4630/4640) not opening to a full 90 degrees could be caused by a couple things: The Opening Force could be set too low. Try increasing the opening force adjustment on the contr...:

What causes the top latch of a 1690 to not hold in the retracted position while the door swings?

Resolution: The top rod is adjusted too short, so when pushpad is pressed it is not operating the top latch enough to get into the hold down position. The top rod would need to be lengthened by turning the lat...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ door postion switch ”

RELATED FAQS