Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ door frame with sidelight rough opening ”

RELATED FAQS

Resolution: POCKET DOOR FRAME: A frame designed to allow a door to slide inside a pocket located within the cavity of a wall. The hinge jamb of the frame is replaced with a 2 piece jamb without a stop. I...:

What is the rough opening in walls for frame installations?

Resolution: For DW, K three sided frames and four sided borrowed light frames: Three sided frame = door opening width (order size) plus 1 1/2" minimum to 2" maximum and the door opening hei...:

Does Steelcraft offer a KD (knocked down) assembly for sidelight frames?

Resolution: Side Light and Side Panel frames - Side Light and Side Panel frames are not KD (Knock Down), they must be assembled and welded. All side lite and side panel frames must be assembled and welde...:

What frame profile variations are available on fire rated transom sidelights and window?

Resolution: Elevation frames are available in: F-Series (F16 or F14) FN-Series (FN16 or FN14) MU-Series (MU16, MU14) Additional parameters of the frame components: Perimeter (Head and Jambs) Frame: ...:

What is the maximum glass light size available on a 20 minute sidelight frame?

Resolution: On fire rated transom and/or sidelight frames and fire rated window frames, Steelcraft labeling procedures only control the O/A width and/or height of the frames based on wall condition. The amount...:

Can fire rated double egress frames have side lights or transoms?

Resolution: No. Fire rated double egress frames must be a stand alone 3 sided frame assembly. If transom lights and/or sidelights are required, they must be built and installed as separate Fire Window assemb...:

What is the maximum frame size for a label transom and sidelight frame?

Resolution: Maximum hourly rating for a transom and side light or panel frame is 1 1/2 hour (90 minutes).In masonry wall application the maximum is 13'6" x 12'2"In stud wall application the maxi...:

What are the frame hinge locations for a 9'0" door opening?

Resolution: From Head to top of each 4 1/2" hinge is 7 1/2", 36 51/64", 66 3/32" & 95 25/64". From Head to top of each 5" hinge is 7 1/4", 36 35/64", 65 27/32" & 95 9/64".:

How many compression anchors are provide per jamb on DW-Series frames?

Resolution: For compression anchor details refer to the “ANCHORING SYSTEMS” section in the Steelcraft Tech Data Manual.Anchor Quantities: • 1 compression anchor per jamb through 9"depth • ...:

What is the difference between the FE and DE-Series frames

Resolution: A Double Egress frame is a double door frame prepared to receive two single-acting doors swinging in opposite directions (both doors are) the same hand. These openings are installed in cross corrid...: