Dezigner trim installation instructions

RELATED FAQS

Question
Answer
It is always recommended to point installers to the industry installation manuals which are very comprehensive and are ANSI documents. SDI (Steel Door Institute) installation manual can be found...
Dezigner Trim – This unique and patented glass trim has been designed to closely simulate trims installed in wood doors and is factory: Supplied recessed into the door face, to provide a neat f...
Flush Mounted Steel Trim for Insulated glass – Designed for 1” thick insulated glass. Recessed into the surface of the door face Accommodates 1" (25 mm) thick glass. When installed, fastener...
Overlapping Steel Trim (also refer to as conventional steel trim) – This trim is the typical glass trim supplied by most hollow metal manufacturers. Surface mounted on the door face. Accommo...
Flush Mounted Steel Trim – This trim is similar to Overlapping Steel Trim but is factory supplied recessed into the door face and is available for 1/4” glass. Glazing stops are screw attached, fast...
 Basic glass trim details:
The L283-150 is a modified mounting plate to allow a user to only install trim on the inside of the L9000.  For installation and door prep requirements, see the install sheet.  Add...
See the installation instructions 718 for -C devices.
Templates for current 718 series trim can also be found on Falcon website
Verify the door thickness is 1 5/8" or greater per the pricebook.  Thin doors will force the clip off the housing.  If door thickness is correct then replace the product as needed.
There is not a wood template for 9957 three point latches, use the 98/99 rim template W10301 to get the correct device backset.  For NL trim (990NL) use trim template and installation instruction W...
Yes, Von Duprin 996L lever handle can be replaced with a new one . Attached installation instructions shown how to replace the existing lever handle on 994/996L trim for rim and vertical rod device...
If the 912L was shipped after February 28,  2011, Check the installation instructions, step 3 to be sure all parts are installed on the trim correctly, even if the trim was received in th...
We ship the standard installation instructions because it contains enough information to show how to convert the trim from mechanical to electrical.
Order E-Trim Mech Kit  part #050671-00 which will include a new solenoid already mounted to the blocking mechanism. See installation instruction # 921297 here which will show how to remove block...