Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ construction programming mode ”

RELATED FAQS

Resolution: Creating a Master Construction Credential - From first power up or after clearing memory: Remove the CT5000 lid. Press and hold the Schlage button. Present a credential to the reader within ...:

Why doesn't my AD lock go into Construction Mode?

Resolution: Update your device firmware to the latest version to fix this early design / feature update:

Why did my CO Lock stop working after the Reader Module (electronics) was changed?

Resolution: CO Reader Modules are not individually replaceable, nor can they be swapped between locks. The inside and outside assemblies of a CO lock are a matched/mated set and cannot be swapped to change rea...:

Can the low coin cell Nuisance delay be Disabled on a CO200?

Resolution: The coin cell is ignored when the lock sets are used with Manual Programming ONLY or while in Construction mode.:

How do you reset an AD-200 back to default?

Resolution: :