Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ configure Cache mode ”

Resolution: An AD400 granting credentials access in “cache mode” will blink the Schlage with the normal green LED, followed by a brief red Schlage LED flash, indicating no RF communication and access was grant...:

What is the SUS feature "Device Template"

Resolution: See the attached Technical Note for instructions on saving a "Device Template" FROM a device or loading TO a device, Device Template Tech NoteOn the SUS/HHD go to the LOCK Properties tab, and sele...:

Cache Mode

Resolution: How the reader will handle stored card information if there is loss of communication to its controller:

What does a blinking TROUBLE LED (D1/D2) mean on my PIM400-TD2?

Resolution: a) One blink of the TROUBLE LED means the AD400 on this channel has low AA batteries. Install fresh batteries. b) Two blinks of the TROUBLE LED means the AD400 on this channel is not communicating...:

What does a blinking TROUBLE LED (D1/D2) mean on the PIB300?

Resolution: 3) Five blinks of the TROUBLE LED means that the AD300 on this channel has used cache mode to allow access during a communication loss with the PIB300 or the Access Control Panel. Press the LINK b...:

The TROUBLE LED on my PIM400-TD2 is blinking five times. How do I stop it?

Resolution: Push the LINK button near the TROUBLE LED once to stop the five blinks.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ configure Cache mode ”

RELATED FAQS