cleaning your product

RELATED FAQS

Question
Answer
To clean the platen on a hand reader, apply a Windex-like product with a clean, soft cloth and allow it to air dry.  The hand reader platen overlay has an anti-microbial surface.  Should ...
Cleaning and caring for the lock will vary depending on the finish. Clear-coated or oil rubbed finishes can be cleaned periodically with a mild non-abrasive soap and buffed lightly with a clean ...
Recommendation is to use mild soap with a damp cloth to clean an exit device.
The only routine maintenance required on a biometric hand reader is cleaning.  The platen surface upon which the hand is placed, the side mirrors, and the overhead window should be cleaned with rea...
When rust appears, repair the affected surfaces by finish smooth, clean, treat for maximum paint adhesion, and touch up the surfaces with a direct to metal (DTM), rust inhibitive primer.
Prime or painted surfaces which have been scratched or otherwise marred during installation (including field welding) and/or cleaning must be field repaired and re-primed by the installing contractor.
Steelcraft does not offer factory powder coated doors and/or frames. Powder coatings usually require heat between 300 to 400 degrees to melt and cure the powder coat. The higher heat can ca...
Hospital Stops are located at the bottom of the frame jambs and/or mullions. The integral door stops are terminates above floor line and is closed with a 45° or 90° angle to facilitate cleaning at ...