Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ chexit power needs ”

Resolution: If Chexit device LED blink once when you turn the unit on, the External inhibit green wire is not by passed or not connected to the access control normally closed contact. For devices sh...:

What gauge wire is needed for CX red and black power wires?

Resolution: For Product Shipped prior to 8-24-2015 with solenoid and EPT or Door Loops: a. 0-100 ft, use #14 Gauge Wire ...:

Why is my Von Duprin Chexit device not lighting up or arming?

Resolution: Devices were shipped from the factory with solenoid driven prior to 8-24-2015. First confirm that you are using a PS873 or PS914 power supply.Measure the DC voltage at the ten wire hardness a...:

Why does the fuse blow in the power supply when arming the Von Duprin Chexit device?

Resolution: The following could cause the fuse to blow in the power supply with devices shipped prior to 8-24-2015 with solenoid driven when Chexit device is arming. Wrong power supply Confirm PS873 or...:

What are the amperage and power supply requirements for the Von Duprin Chexit (CX) devices?

Resolution: Chexit motor driven devices shipped after 8-24-2015:You can use 1 Chexit device with PS902, 3 Chexit devices with PS904, and 4 Chexit devices with PS914 or PS906 power supplies with proper gau...:

How many Chexit devices can be operated from the PS914 power supply?

Resolution: Following information determine number of the Chexit devices that were shipped prior to 8-24-2015 from the factory with solenoid driven can be hooked up to a single Von Duprin PS873 or PS914 p...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ chexit power needs ”

RELATED FAQS