can i flush mount schlage readers

RELATED FAQS

Question
Answer
The Schlage MTMS15 and MTMSK15 readers are multi-technology readers designed to work across many different types of systems.   Since there are many different magstripe clock/data formats, t...
The 9550 series Senior Swing WILL NOT work on a pair of doors with auto flush bolts. The 9560 series Senior Swing and a sequence module are required when used on an pair of door with auto flush b...
Yes. Multiple glass lights are available on specific door series as  a special option as noted below: L-Series and SL-Series: Core options - Standard honeycomb, polystyrene, polyurethane Lig...
The Schlage Smart and Multi-Technology Readers by Allegion have been approved by the U.S. Government under HSPD-12 for FIPS 201-1 compliance as PIV Transparent Readers.
All read ranges are affected by the environment the reader and card are subjected too.  The following data was obtained in a relatively "noisy" RF area with the reader mounted on a metal ...
All read ranges are affected by the environment the reader and card are subjected too.  The following data was obtained in a relatively "noisy" RF area with the reader mounted on a metal ...
         
  The Legacy wall mounted readers are replaced as shown in the table below:  The MTMS15 and MTMSK15 did not have any prior models that it replaced.
On a single door take the mounting dimensions from centerline of pivots.  On a pair of doors, depending on the door width and pivots being used, the operators can butt up against each other or ov...
The TK400 kit contains an PIM400-TD2 and a WPR400-DT (Dummy Trim) and charger. The WPR400-DT reader has no electronics it is an empty plastic shell. Since the WPR400-DT does not have electronics ...
If a factory default reset (FDR)  is absolutely needed, you MUST temporarily replace the credential reader with another reader that has a Schlage Button.  This should be rarely if ever required. T...
Dezigner Trim – This unique and patented glass trim has been designed to closely simulate trims installed in wood doors and is factory: Supplied recessed into the door face, to provide a neat f...
Flush Mounted Steel Trim for Insulated glass – Designed for 1” thick insulated glass. Recessed into the surface of the door face Accommodates 1" (25 mm) thick glass. When installed, fastener...
Overlapping Steel Trim (also refer to as conventional steel trim) – This trim is the typical glass trim supplied by most hollow metal manufacturers. Surface mounted on the door face. Accommo...
Flush Mounted Steel Trim – This trim is similar to Overlapping Steel Trim but is factory supplied recessed into the door face and is available for 1/4” glass. Glazing stops are screw attached, fast...
 Basic glass trim details: