Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Cam Lift and Power operator ”

Resolution: The Senior Swing will work with Cam Lift Hinges as a PUSH SIDE MOUNT 9542/9553/9563 only. Maximum 3/4" lift. Maximum 15 pounds force to push door up the Cam Lift Hinge. Cam Lift Hinges WILL NO...:

What is a Cam Lift Hinge?

Resolution: Cam Lift Hinges are specially designed hinges used mainly on acoustical door assemblies. The Cam Lift Hinge lifts the door during its travel and seats the door bottom for a pos...:

Can a Cam Lift hinge be used with LCN closers?

Resolution: Cam Lift hinges can only be used with LCN door closers that have a "Regular" or "Reg hold Open" style arm. Locating the Closer and Arm from the centerline of the pivot point of the cam lift h...:

What is the power draw of a Senior Swing series operator?

Resolution: The Senior Swing (2800/9500) Series operator has a 120VAC @ 2.5 Amp current draw for a single door (2811/9531/9542) or simultaneous pair(2853/9553). The independent pair units (2863/...:

How do you wire an electric strike to a 4600 Series operator?

Resolution: The 4630/4630 operator has a 12 VDC and 24 VDC output that can power an electric strike or maglock. The wiring diagrams are shown on page 14 of the installation instructions (attached). 4600 Insta...:

Why would an LCN 8310-865 RF Receiver have a flashing "RED" light?

Resolution: When the "RED" LED on the 8310-865 RF Receiver is blinking, it is receiving an RF signal (interference) from a non programmed device. When receiving this type of signal, it will not ...:

Can you operate a Doromatic EL 1490 with an LCN power supply?

Resolution: This is not possible. Due to the device's 16 Amp in-rush it would require it's own PS914-2RS which will power 1 or 2 devices.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Cam Lift and Power operator ”

RELATED FAQS