Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
AL series timing guide
”
RELATED FAQS
Question
Answer
What backsets are available on Schlage and Falcon locks?
Resolution:
SCHLAGE locks are available with the following backsets: Lock Series Lock Type  ...:
How do you remove an AL lock from a door?
Resolution:
AL-Series and discontinued D Lever-Series locks use castle nuts to hold the chassis to the spring cages and to keep the chassis positioned in the door. This causes confusion at times when the lock ...:
What is the Buy American Act (BAA)?
Resolution:
To obtain product certification forms:Download the BAA Catalog on the Allegion website Complete the information requested in the the BAA Catalog with a detailed copy of the prod...:
How do you convert an AL44 to an AL40?
Resolution:
To convert the AL44 to an AL40 you can replace the outside plunger unit in the chassis or order the AL40 chassis. Replacing the plunger unit is more difficult and time consuming and would not be r...:
What is the part number for an AL Series cylinder?
Resolution:
Refer to table 1 for the list of Schlage AL-Series cylinders. AL-Series Cylinder Reference Table Function Cylinder Mechanism Complete Cylinder Non-Hotel Functions ...:
What is the difference between the standard lever inserts for the pre-2002 AL and the old D Lever?
Resolution:
The old D-Series Lever used a standard lever insert similar to the pre-2002 AL-Series standard lever insert. The old D Lever insert was smaller than the AL and the two were not comp...:
Does Schlage or Falcon offer a backset greater than 5"?
Resolution:
Only the Schlage D-knob and ND products are available with an extra long backset. The part number for backsets over 5"-42" is XC03-069, this part will ship as an extension link to b...:
How do you remove an AL series lever?
Resolution:
See instructions below. :
Schlage AL small format spacer installation requirements.
Resolution:
The Schlage AL-Series SFIC locks require one (1) small format spacer (D500-000) for 7-pin cores and two (2) small format spacers for 6-pin cores. When these spacers are not ins...: