Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
al series install
”
RELATED FAQS
Question
Answer
Schlage AL small format spacer installation requirements.
Resolution:
The Schlage AL-Series SFIC locks require one (1) small format spacer (D500-000) for 7-pin cores and two (2) small format spacers for 6-pin cores. When these spacers are not ins...:
New FSIC driver info for the AL locks.
Resolution:
The new AL FSIC driver part number is A700-052. This driver snaps onto the back of the core similar to the ND, as opposed to it being assembled into the lock chassis with a retaining ring. Th...:
Why can't I remove the control key from the core after the core is inserted into the lever?
Resolution:
The lever may be missing the slot feature for the core locking lug. Verify slot is in place.:
Why can't a new spring cage or driver be installed on an older AL lock?
Resolution:
In 2002 the Schlage AL-Series underwent a design change that affected the spring cage, driver, and plastic insert. Spring cage and driver replacements for AL locks manufactured before this design ...:
Can you install a Schlage S lever on an AL lock?
Resolution:
You can not install the S lever onto an AL lock. The AL and S lever trim is not compatible with each other.:
AL-Series Plunger Assembly Instructions
Resolution:
Changing the plunger assembly on the AL-Series requires disassembling the chassis. Refer to Plunger Assembly Instructions for guidance.:
How do I identify an AL lock?
Resolution:
The AL-Series has four distinguishable parts that can help in lock identification. 1. The AL-Series will have a castle nut holding the chassis on the ...:
Where is the cross reference list for PS800 to PS900 series power supplies?
Resolution:
Von Duprin PS914-4RL power supply replaces the PS873-4TD.:
What height should a lock or deadbolt be installed?
Resolution:
According to ANSI specifications for cylindrical or mortise locks: The lock strike centerline should be 40 5/16" from the bottom of the frame with the lock in relation to the strike.&...:
Can the credential reader be changed on a CO-Series lockset?
Resolution:
A Credential Reader MAY be replaced with another Credential Reader of the same type; however, a Factory Default Reset must be performed before the lock will function properly.:
How many compression anchors are provide per jamb on DW-Series frames?
Resolution:
For compression anchor details refer to the “ANCHORING SYSTEMS” section in the Steelcraft Tech Data Manual.Anchor Quantities: • 1 compression anchor per jamb through 9"depth • ...: